- Your shopping cart is empty!
Tunze Comline® DOC Skimmer 9012 DC
The Comline® DOC Skimmer 9012 DC is one of (if not the) first true “surface skimming” protein skimmers ever designed (check out its little brother Comline® DOC 9004), and all with the new top - end DC motor! Think about it; the reason most of us go through all the hassle and expense with a sump/pumps/overflow box, fittings, lines etc is to get the protein-rich surface layer on top of the tank to the skimmer, right? At Aquatic Warehouse, we have loaded up a 37gallon soft coral reef tank, whereas we cannot stuff in another coral, and it is a stunning reef tank with only the Tunze 9004, a Tunze 9062 filter and a small powerhead (and heater).
The Comline® DOC 9012 DC Protein Skimmer is designed for use in saltwater up to a whopping 370 gallons! (lightly loaded) or 180 gallon heavily loaded reef. It operates according to the Tunze® “Flash Skimming Principle” and acquires the water through an efficient surface suction with a surface film removal.
The TUNZE® Foamer generates large volumes of fine air bubbles and is especially quiet during operation. The “Flash skimming” principle enables highly efficient foam production. Organic-rich surface water is mixed thoroughly with small air bubbles in the TUNZE® Foamer. On the top surface of the air bubbles, pollutants such as protein, cellulose, dead cells, etc. are absorbed immediately.
The water/air mixture expands and stabilizes in the skimmer cup reactor, the water returns to the aquarium, and the protein-loaded air bubbles spill over into the skimmer cup. The patented anti-over foaming system intermediate chamber prevents the skimmer from over-foaming and controls the skimmer performance, depending on the water level and organic load.
The particularly high efficiency of the “flash skimming” principle, compared to large skimmers with long contact time, is obtained because the substances absorbed by the air bubbles are not released again, thus they don‘t return to the aquarium water.
A true surface skimming skimmer! Takes the place of needing a sump.
- High End German DC motor and Controller!
Uses only a messily 17 Watts!!
Comes with an air intake silencer
Silicon buffers to prevent vibration on the aquarium glass
Reduces outgoing bubbles always found on hang-on and internal skimmers
Best if used up to 1/2” thick glass or acrylic tanks
Internal pump flows 105 gph and exits the skimmer in the bottom
Attaches with strong German magnets (we have found at AW, that the it is best if supported with a piece of live-rock under the skimmer so when you push down on the collection cup, it will in no way move)
Total dimensions; 5.5” length (magnet side)x 4.3” width x 16.3” height, with Immersion depth: approx. (10” to 11”), (255mm to 285mm)