- Your shopping cart is empty!
The Neptune PMUP Pump - Apex-Ready
The Neptune PMUP (practical multi-purpose utility pump) is an outstanding Apex-Ready pump that can be used for many different tasks on your aquarium. The most popular uses will be for:
- Automatic Top-Off (ATO)
- Carbon Reactors
- GFO Reactors
- Bio-Pellet Reactors
- Neptune Apex Controllable
- Many other salt or freshwater uses
The PMUP is a 24VDC submersible pump that was designed to directly connect to the DC24 accessory ports on either the 1Link module OR the same ports on the new Energy Bar 832. If you own our WAV powerheads or our new Apex, then you have a place to plug it in! These ports are switchable and can power the pump on and off just like any other outlet on an Energy Bar.
The PMUP is a multi-purpose pump that can be used for many different tasks on your aquarium like:
ATO will likely be the most popular use for this pump. And unlike many wimpy pumps out there, the PMUP has enough pressure to push water up 14 feet vertically, it can even move the water up from one floor below.
This means you could put your RO water storage in your basement or downstairs in a utility room and it could still pump it up to the tank.
It also has a vertically oriented design with a bottom intake and top output that is perfect for use in jugs or other RO containers. Just drop it in!
Run your reactors safely and with less energy
The PMUP is not just for ATO. It is also a great pump to use for running your various reactors bio-pellets, carbon, GFO, or even the two-stage combo unit from BRS you see here.
The PMUP uses less than 20W of power so it is a very efficient way to run reactors and adds very little heat to your aquarium.
We’re certain there will be many other uses found for the PMUP we’ve not even considered yet.
Easy to connect with standard tubing and fittings
The PMUP Has a smooth, 3/8″ (9.5mm) output that will easily connect to silicon tubing or standard push-fit connectors like the one shown in this image.
- Dimensions – 4.58″ x 2.24″
- Output – 100gph @ 0′
- Max Head – 14′
- Power – 17W
- Apex (any model)
- 1Link module or Energy Bar 832 with available DC24 accessory port