Neptune Systems COR-20 Intelligent Return Pump 2000 gph

Neptune COR-20 Return Pump                                                                                                        

Super Quite and Intelligent,  all of the COR pump models are Energy Efficient and fully compatible with every Apex system on the market. Simply connect the COR pump driver to any available AquaBus connection on your Apex system and then run the setup task in Apex Fusion. It’s that easy!
The COR-20 puts out great flow while at the same time being super-stingy on power making it friendly to your wallet and the environment! Be sure to plumb the COR-20 using the largest diameter pipe possible to get the best performance. We recommend at least 1.25″ 

NO APEX NECESSARY!

While an Apex connection is not required, the COR was built from the ground up with Apex controllability in mind. Connect the COR to the Apex and control your pump output percentage, get real-time operational feedback from the pump, integrate it into complex feed routines, and monitor the status of the pump from anywhere in the world via Apex Fusion. Connect the plumbing, plug the COR into its driver and plug it in to an outlet. With just a few button presses you will be able to set the pump flow rate and feed modes. If you connect it to an Apex, a set up task will take you step by step through the entire install process.

FEED MODE

With a few button presses (standalone mode) or some simple configuration in Apex Fusion, you can set a Feed Mode that will slow the pump to any level you choose. When connected to an Apex, you can even have other tank operations sequence with this feed mode and the time interval of the Feed Mode can be customized as well. When connected to an Apex, the buttons on the COR driver also function as an easy to use feed button.

OBSTRUCTION DETECTION

Snails, filter pads, or other foreign objects often find their way into a pump. Should the intake to your COR or any of your plumbing become significantly obstructed, the COR will alert you by flashing the LED on the driver. When the COR is connected to an Apex and the internet, it will send an alert to your mobile device as well.

INTERNAL TEMPERATURE MONITORING

The pump driver is continually monitoring the internal temperature of the COR pump motor. If it reaches an unsafe level, the driver will slow the pump down just enough to bring the temperature into an acceptable range while also providing you a notification. Some pumps shut off completely when they have a temperature issue, but the COR slows down so your tank will continue to circulate — giving you time to address the problem.

REQUIRES:

• Plumbing fittings, hose, pipe, etc.
• Basic plumbing knowledge

INCLUDES:

• COR Pump
• COR-20 Pump Driver
• 100W 24VDC Power Supply
• Power Cord
• 1.25in. PVC Union (Slip->BSPP)
• 1.0in. Slip Fitting
• 0.75in. Slip Fitting
• 3-foot AquaBus Cable

PHYSICAL DIMENSIONS:

• PUMP:  3.875”W xv4.875”H x 6.250”D
• DRIVER:  3″W x 4″H x 1″D